Post by nick89890 on Aug 14, 2022 8:54:17 GMT -5
Hi Guys
i have a standard vertical mill with a manual quill
I would like to use the mill for vertical boring
the head can be powered up / down. Not sure if I could use this for boring. I think it is too fast.
Maybe I could install a speed controller on the head motor ?
I have seen Stefan G, youtube video where he makes a motor to fit onto the fine feed, seems a lot of work.
does anyone produce a suitable adapter system?
cheers Nick
i have a standard vertical mill with a manual quill
I would like to use the mill for vertical boring
the head can be powered up / down. Not sure if I could use this for boring. I think it is too fast.
Maybe I could install a speed controller on the head motor ?
I have seen Stefan G, youtube video where he makes a motor to fit onto the fine feed, seems a lot of work.
does anyone produce a suitable adapter system?
cheers Nick